Among Us Crewmate - No Support - Dead and Alive

thingiverse

This is a crewmate from the game Among Us. The model can be printed as one solid torso or can be printed in two separate parts along with the bone and can swap between the dead state and alive state. <h1>Supports</h1> All models apart from FullBodyWideLegs are supportless and should all be in the best orientation for printing but let me know otherwise (Model shown is WideLegs variant) If it's requested, I can modify the model for dual extrusion printing <h1>Tolerances</h1> The bone has a tolerance of 0.15mm, I can add more tolerances if requested. Visor comes in 0.3mm, 0.15mm and 0.075mm tolerances, I can add more tolerances if requested. I recommend the 0.15mm visor for a tight friction fit. Note: when scaling up/down the model, the tolerances also scale by the same factor (i.e. printing the 0.3mm tol visor at 50% scale will then give it a tolerance of 0.15mm), so be sure your tolerances are correct before printing.