Amiga Gotek OLED 128x64 0.96" display with rotary encoder

thingiverse

Amiga 500 128x64 0.96" OLED display case utilizes a rotary encoder mounted on the grill at the rear of the Amiga 500, specifically designed for PAL A500. The optimal printing method is to have the face down, ensuring precise positioning and minimal risk of damage. To achieve a 90-degree angle for the pins, bend them with the plastic locator in place, then carefully break it up using flush cut wire snips. Be cautious not to damage the board or screen. The retaining clip does not come into contact with the OLED display; instead, use foam tape to secure it in place. This design choice was made to prevent potential cracking of the display due to excessive pressure from the clip. This case is designed for OLED displays with round mount holes. If you have an elongated hole type, compatibility may vary, and further investigation is recommended. Remember to update your config file, ff.cfg, to accommodate the 128x64 display by setting "display-type = oled-128x64".