Amiga 4000 CPU card support

thingiverse

This is a CPU card support specifically designed for the Amiga 4000, but it's worth noting that it's not fully symmetrical due to differences in the cylinder diameters at each end - one measures 4mm while the other is slightly smaller at 3.7mm. I created this design with an A3660 CPU card in mind, and the larger hole diameter on the card proved problematic when aligning it with the motherboard's holes. To ensure accurate printing results, I strongly recommend that you rotate this model by 90 degrees within your slicing program before laying it flat on the heatbed. This will allow the cut inside the cylinders to run vertically, which is crucial for achieving the best possible outcome using zigzag support techniques. If needed, I can provide a pre-rotated STL file at a later time.