Amazon Echo Show 5 Wall Mount

thingiverse

UPDATED VERSION 2.0 (JUNE 2022) Improvements were made in the thickness of the walls to give it more resistance when printed with PLA, notches were added to the supports, the main support was reinforced and brackets were also added to be printed and secure the piece on the wall. It is recommended to print the piece and with a marker, scratch the internal silhouette of the piece on the wall and then offset that edge at least 2mm outwards to proceed to make the hole in the wall. For the best orientation on the printing bed, see attached images. A 15-20% infill is recommended, and if possible, add a support in the middle area. Recommended 0.28 - 0.4 for printing. PLA. Attached the file in STEP, 3MF and obj. Free to use, not for sale! ********************************************** A Wall Mount for a Echo Show 5. Make the internal silhouette with a marker to make a hole in the drywall using the pattern in the file attached, be carefull to not modify the size of the print, it must be the same size of the print. Then add drywall compound (like drydex or similiar) to fix the wall mount. I add a for sections to add an mounting bracket. If you are not going to use bracket, can print the part perfect in 20% infill or less. If you're planning to use bracket, it will be better with more infill. Personally y prefer the compound only. I recommend placing them near a power switch, and taking out an electrical connection from the same switch with an inexpensive extension cord inside the wall.