Amazon Echo Dot Wall Mount

thingiverse

This is another version of a wall mount for the Amazon Echo Dot printed using the following settings: Layer height: 0.2mm, Perimeters: 3, Top and Bottom layers: 4, Infill: Rectilinear 50% (could be 100%), Print with PLA at 205C nozzle and 60C bed. To ensure the grain is right for strength, you must print the three brackets on their edge; the base needs to be printed with the slots uppermost. You may need a little gentle filing to fit the brackets and they will need to be superglued into position, then clean up the countersinks to ensure the fixing screws sit flush. Print Settings Printer: E3D BigBox Rafts: No Supports: No Resolution: 0.2mm Infill: 50% Rectilinear Notes: Print one of Part1 with rectangular slots up, print three of Part2 on their edge, use 3 perimeters and 4 top and bottom layers. This works well with PLA printed at 205C for the nozzle and 60C for the bed but use whatever your printer is good with. Post-Printing You may need a little gentle filing to fit the brackets and they will need to be superglued into position, then clean up the countersinks to ensure the fixing screws sit flush.