AM4 Bracket adapter for XSPC Waterblock

prusaprinters

I'm not sure what model this block is since I couldn't find it anywhere on the website. The block(with the stock bracket removed) is somewhere around 50x50mm. Should fit snugly. Print with relatively high infill and 4 shells minimum. Take off the stock bracket with the 4 screws on top. My motherboard used 6/32 screws to attach the heatsink. You'll need longer ones I decided that 25mm was the right length but they only come in inch lengths so 1 in is fine. Make sure to tighten it in the cross pattern(corner to corner) to make it go. Print Settings Printer Brand: FlashForge Printer: Creator ProRafts: Doesn't Matter Supports: No Filament: Who cares ABS or PETG Notes: Print in a higher temp filament. This part will have to withstand temperatures of up to 100C in the worst case without warping. Category: Electronics