Altoids Tin Chess Set

prusaprinters

<p>They are meant to accept 4 mm X 2 mm disk magnets. You can find these cheaply from China on eBay. I was trying to figure out how to make a magnetic chess set without using a stupid amount of magnets. It occurred to me that a flat steel sheet would work, but I had none. These tins on the other hand, I have tons of. They only cost a few dollars anyway and come with mints.</p> <p>I suppose you could also toss them on a fridge or the hood of your car.</p> <p>The pieces fit upright with the lid closed just fine. They measure about 7 mm diameter at the base of each piece.</p> <p>Included is a scaled board for printing.</p> <p>Thanks to PerryT for the original models.</p> <p>I recommend using the tweezers made by MechEngineerMike<br/> These are located at: <a href="https://www.thingiverse.com/thing:2627753">https://www.thingiverse.com/thing:2627753</a></p> <h3>Print instructions</h3><p>Print in as fine of detail as you can. They look good in resin too.</p>