Alternate Filament Feed Pulley

thingiverse

Widened the center of the pulley a little bit and rounded the edges to give it a 'fatter' look. This will mount fine in the original creators bracket, as well as in the alternative bracket I remixed. The diameter for the pin to attach the pulley to the bracket is also unchanged. Extruder Temp: 200 Bed Temp: 62 Speed: 60mm/s Fan: 90% I used a brim since there was not a lot of contact between the pulley and build plate, so I did have to lightly file some minor edges off. I am not certain it was required.