almost compact vape box mod [e-cig]

thingiverse

Hello vaping friends! If like me you have tanks with outsized dimensions to limit the burden of filling, you may want a mod that allows you to use clearomizers up to 30mm diameter and 65mm height without exceeding. This is a DIY box easy to assemble (for sure...) developed around pieces found on FASTTECH. List of required parts: - The parts to print :-) - An Eleaf Istick Pico compatible control module. https://www.fasttech.com/p/5573600 - A push button that works fine https://www.fasttech.com/p/2013501 - A 510 support https://www.fasttech.com/p/2245600 - A 18650 battery holder https://www.fasttech.com/p/3828301 The use of a remote fire button requires welding two wires on the button present on the control module. Steps for assembly: First of all, a little bit of welding. In addition to the wires for the "fire" button, it is also necessary to extend all the wires present on the control module and solder two wires to the connector 510 (one at the base for the "+", and one on the terminal for the "-" ) Then, the most effective order: 1- Mounting the support 510. Leave the wires previously soldered by the battery door (and the others later). 2- Set up buttons "+" and "-" (2X "Boutons_Q") at the bottom of the box 3- Set up the control module, the USB port must be pushed into the hole provided. 4- Screw on the fire button in the "Couvercle_batt" 5- Fire button connection and cover installation This step is the most delicate, this cover is intended to constrain the control module, but the wires can hinder and force a little. When setting up, check that the "+" and "-" buttons keep their slack. This lid holds in place without glue and therefore remains removable. 6- Connect the remaining wires to the battery holder. 7- Set up the battery holder, put a small dot of glue to finish. The hood of the battery door is all alone, but we can add, after drilling small holes on the left side of this hatch (5mm wide), small neodymium magnets for more support. For cabling and my mapping skills, see picture ;-D In order to use with short tanks (normal ones, so...), you can get some heat sinks like this one: https://www.fasttech.com/products/5843003