All printed adjustment feet for Lack Table

thingiverse

Adjustable leveling feet specifically designed for the Lack table enclosure are available and can be easily installed. These innovative leveling feet eliminate the need for additional hardware, requiring only a single screw to secure them to the bottom of the lowest table in your stack. The screws themselves can be printed without supports if they are printed at a slower rate to allow for proper thread formation. A small hole is strategically placed at the bottom of each screw, allowing users to utilize a standard ratchet driver for added leverage when initially tightening the screw. This may require some back-and-forth motion to clean up any excess plastic from the printing process.