All-in-one fan duct for E3D v6

thingiverse

I've been using a single fan duct to cool my printing material for over a year now, and it's generally done the job decently well. However, I've found that there are specific models where its performance is severely limited, and no amount of redesigning the duct has managed to improve things significantly. This particular design utilizes two 40mm fans, one on each side, which can be printed in a single piece without support - although the upper arch of the outlet might pose some issues if you're not using a cooling fan. To avoid any problems, I've carefully positioned the air blow point just below the nozzle area, making sure it's not too wide. While this setup isn't perfect, it has produced the best quality results I've seen so far. If you have any suggestions or improvements to offer, please let me know. Print Settings Printer: DIY H-bot Rafts: Doesn't Matter Supports: No Resolution: 0.2 Infill: 30