Alienware x14 Stand Dock

thingiverse

**Alienware x14 Stand** I use 4 monitors at work and wanted a docking station stand I could just drop my x14 into. I use a WD19TB Docking station at work. This has been working great for the past 3 months. **Legs** Made these with venting in mind which is why there is a big hole where the laptop sits. I don't have any issues with overheating. The smaller holes in the back were to potential run wires for an RGB strip. - Choose between the Alienware Logo or No Logo - Print with the logo side up, and crossbar insert on the bottom - Print one normally, and the other one using the mirror option - Tree supports in Cura. - Feel free to test without supports. - Don't use full supports it will be too hard to remove it from the vent hole **Crossbar** The cutouts for the usb-c thunderbolt ports were made to be tight fitting for the Dell WD19 Docking station cable. I made the HDMI cutout bigger using a fatter cable I have. I don't' use the other ports but I made holes just in case. - The bar is not symmetrical. I had to move the usb cutouts quite a bit to get it dock properly. - Print Diagonally and flat - Use minimal supports. The connector inserts need it.