Alienware Monitor Webcam Mount (AW3420DW)

prusaprinters

<p>Due to its odd triangular profile, a webcam will not sit well atop the Alienware AW3420DW. This is a simple mount that provides a mounting surface. This was designed to fit the mount used by the logitech brio, 920, 922, 925, 930 and any other webcams that use the same mount. Other generic mounts tend not to work as the bezels are quite thin.</p><p>I've left the fit slightly loose front to back and I've stuck a piece of foam tape (3m double sided, but left the film on one side) on the piece that sits against the front of the bezel. Any soft-ish material will work (couple layers of masking tape, cork, foam, sticky tack, etc.) just to prevent the possibility of the PLA scratching the bezel.</p><p>I've also used a velcro strap to secure the webcam to the mount, though this is likely overkill. ( a ziptie or piece of string would work as well)</p><p>I've printed this in PLA, though the material is essentially irrelevant. It's a small part, so I've opted to print it upside down with default support material settings enabled rather than breaking it into multiple parts to avoid supports.</p><p>Modeled in inches, so if it comes up tiny when opened, scale by 2540% to convert from mm to inches. PrusaSlicer and S3D do this well by default, Cura does not.</p>