Alien Dab

thingiverse

Here's an alien I created and positioned. The uploaded file is sized to be 200mm (7.87 inches) tall. I printed him at full scale and it turned out decently. It took about eight hours to print, printed in ABS with 10% infill, and sliced using Slic3r. The photos will show surface banding and issues that were caused by my printer; these issues have been resolved and I may reprint him to get a better quality surface. Lastly, as you might've noticed, the image showing his mouth was printed terribly. This was my fault - the supports I generated were not sufficient. Please learn from my mistake and ensure the supports you generate will support his mouth properly. The feet / base is completely flat and the print should stand upright just fine, though it isn't perfectly stable. If you end up printing this guy, please post a "Make", I'd love to see your prints!