AkroBin End Cover

prusaprinters

<p>I noticed that the AkroBin on my Hornady press started overflowing before it was filled to capacity due to the open area on the end of the bin.</p> <p>I made up a few designs to help with this: one requires some minimal supports (the standard version) and one requires no supports (the short version), although there is about a 1/4" gap on each side of the cover. The gaps would be fine for almost all standard cases or loaded ammunition, but something like a .223 bullet could possibly slip through. If the gap is no problem, you can save a bit of time and filament by printing the short version. On the standard version, the supports do break off very easily and cleanly though.</p> <p>Looks like both Hornady and Dillon use these bins. My AkroBin is model 30210, but I think would fit any others that are 4.125" width.</p> <h3>Print instructions</h3><p>For standard version, print longest direction vertically and just have supports immediately under the area not touching the build plate - there should be no other supports required, so you can block them out if needed.</p> <p>For short version with gaps, print longest direction vertically and no supports are needed.</p> <p>I printed mine in PETG, .4mm nozzle, .2mm layer height, and 25% infill.</p>