Akali's face decoration (glow-in-the-dark)

thingiverse

This is a personal project where I modeled over a couple of screenshots from the League of Legends music video, K/DA - POP/STARS. I really liked Akali's mask design on that video and, since I wanted to test my newly acquired glow-in-the-dark PLA, I thought..."why not?" I printed the parts and glued them over a round wook frame so I could hang up on my wall. The material is of great quality and glows really well. The results were even better than I expected! =) I attached the two screenshots that I modeled the pieces over. I actually picked some sizes and orientations for each part that I thought would go well with each other. Basically, the final model is not present on any frame of the video. I manually put it together to my taste. I also tried taking a photo to demonstrate the "glow-in-the-dark" aspect of it....but it was kinda hard without messing up the brightness. Seriously, the final result is great as long as you're using good material. I added a "guide" image to show the distancing and angle between pieces, since they need to be glued individually and doing it by eye could cause them to end up crooked. The circle on that image is just to show how a circular frame would look around it and where to center the pieces.