Akai S5000 BlueSCSI mount

thingiverse

This is a mount to hold the BlueSCSI SCSI to SD solution in an Akai S5000 or S6000 sampler. The S5000 only has one drive bay, and in my case I wanted to keep the front factory so I left the 3.5" floppy drive in place and created this to allow pulling the SD card from the sampler from the rear. Not as convenient as having it in the floppy bay, but still allows access to pull the card to add and remove data from it. I used 3mm hex screws + lock washers + nuts to hold this in place. There is a tab at the end for using a tie wrap to create a block so the card doesn't slide backwards into the sampler. I also uploaded a 2019 version of the sketchup file so you can edit it with the free version of sketchup if desired. I printed with PLA+, support on, face down on the bed with it set to 220 degrees. I don't know if there are variations on the BlueSCSI so eyeball what I have versus yours.