Aivascope 1.5x anamorphic lens grabhole clamp support

thingiverse

A Custom Support for the Aivascope 1.5x Anamorphic Lens The concept is straightforward: remove the articulating ring (secured by Nylon screws) from the Aivascope, then push the lens through the hole of this support and screw it directly into your taking lens (using step-down rings as necessary). Rotate the lens so that the squeeze sits properly and secure it with the Nylon screws inside the clamp. This approach provides a tight and secure connection while still maintaining full support for the Aivascope, rather than placing excessive weight on your taking lens and camera. Instructions: The three holes surrounding the ring are designed to accommodate M3 threads, which must be cut manually after printing. You can reuse the Nylon screws from the Aivascope or purchase new ones. The rail requires a 15mm rod clamp with a width of 40mm (various sizes are available; ensure yours is 40mm or obtain one that fits). The length is sufficient for use in ARRIs standard LWS system, measuring 85mm in height. When cutting threads, it's essential to maintain sufficient wall strength and proper infill; I used a 50% infill with PETG material (PLA was also used). Special thanks to Tomas for allowing me to measure his lens and providing demo photos. Visit Tomas And Liza on Instagram at https://www.instagram.com/tomas_and_liza/