AirTags Holder for Keychain

thingiverse

This is another keychain holder for Apple AirTags. I started designing right after the announcement but waited for my AirTags to arrive before publishing to make sure it fits well. So: Yes it does and here it is :-) In this final version I used the Apple AirTag Model by mediaman to create the space for the AirTags. You need to print both parts and turn them together. Should print without any difficulty - no support required. I used 25% infill and 0.2 layer height. Make sure to position the upper part 45 degrees clockwise (compared to the lower part) when putting together and turn back 45 degrees anti-clockwise to align the keyring holes as you can see in the picture with the green print. (Other direction will not work as well because of the pins that help holding the parts in place. Yes, next version could have both pins on same part :-) ) If you want to open it again you need to slightly bend the the two parts apart (as seen on the other picture with the green print) to open the lock and twist the upper part clockwise. Depending on the print quality (and maybe the material used) it might be helpful to turn the parts several times without locking (so not aligning the keyring holes) to clean up the print and have the parts turn more easily. It also helps opening later. If you have any comments/remarks/improvements I would like to hear from you. And please post a picture of your makes! EDIT: I added 2 new files: Changes: Diameter of the keyring hole = 6mm, wall around keyringhole = 1.5 mm. Increased size of the alignment holes, minimally decreased size of the alignment pins - slightly replaced the alignment pins so that they are not at the same distance from the rotation center.