AirTag Keychain Case

thingiverse

I designed this Case to be as thin and small as possible. It's not very hard to print and doesn't require a SLA printer. I achieved quite good results with my CR-10 with a 0,4 Nozzle using PETG. The two parts are designed to be held together with a 1mm steel Pin. The pinholes have custom supports and therefore need to be drilled through after printing. You can also just glue the two parts together if you prefer that. The Battery stays replaceable while being installed in the case. It's designed to be printed at 0,1 mm Layer height. The bottom has custom supports build in. The top requires some regular supports. Designed with Fusion 360