Airsoft unloading tool (Updated V2)

thingiverse

A Simple Tool for Rapid Magazine Unloading This handy device speeds up the process of emptying mid and low capacity magazines, making it easier to reload. To use it, simply place the tool on top of an empty BB bottle, then insert your magazine into the top slot. The magazine will be unloaded back into the bottle without spilling a single round. I've since upgraded this design with Version 2, which provides a better fit for magazines and reduces any potential issues during use. While I've only tested it with M4 magazines so far, I'm confident it'll work just as well with other similar models. Print Settings: Printer: Wanhao Duplicator I3 Rafts: Not Required Supports: Not Necessary Resolution: .1 mm Infill: Choose Your Preferred Level Notes: When printing this tool, I used a resolution of .1 mm and 100% infill with no supports. The result was a clean-looking device with minimal mess inside the magazine compartment. However, for best results, consider adding supports to prevent any internal mess during printing.