Airsoft SSG69 Silencer

thingiverse

Designed this mock suppressor to fit an ASG SSG69 Airsoft barrel. I purchased the tight bore barrel and was seeing that I needed to buy a suppressor as the new inner barrel was longer. Well this wasn't the case and it was the same length. Looks like I saved £20. Anyway it is designed to friction fit on the outer barrel endcap. Mine doesn't need gluing onto the cap but dependant on your print you may or may not have to. The suppressor sits about 100mm longer than the outer and about 120mm over the barrel. Once glued/fitted on the endcap, it will screw and unscrew as a mock suppressor. its 40mm diameter I printed at .28 and used filler primer to smooth off. There is another suppressor with a quick design on it just for laughs. Edit: I have made three new variations of the suppressor. One is the same size as the original suppressor but I have incorporated a threaded endcap in case people want to add foam pads at the front. I haven't tested these, but the threads have been adjusted for 3d printing. Don't use supports. One is 320mm long which extends backwards to give a short barrel look. This is for CR10s and similar sized printers One is 240mm long with the end cap so a little smaller and will fit on an ender 3, again extends backwards. Enjoy