Airsoft Shotgun Shell Holder (Remix)

thingiverse

Remix of "shotgun holder for 12ga by juan_bear" I was asked to print his design for airsoft shotgun shells, but upon inspection the holes were too small for an airsoft 30 round shell. I resized his model and made the back part thicker, mainly as I wanted to add a circular channel to take a silicone tube for resistance. The channel is 6mm. You can use 5.5mm to 6mm silicone tubing. there is a cap to push on the end of the tubing and then into the end of the channel, this will give and end cap and a nice tight fit. I've included 3 variations; 1 is a standard resized model with a thicker back 2 is the same but with the added channel 3 is the same as the 2nd one but with a cut out for an easier installation of the silicone tube (I haven't tested this design) The idea is to use hi strength adhesive velcro to attach it to the gun. Hope you enjoy