Airsoft PM-9 inspired Kit for KWA/KSC M11A1

thingiverse

I was tired of waiting for an airsoft PM-9, so I decided to make one. This kit fits the KWA/KSC M11A1 NS2 (not sure if it would work with HFC or NS1 models). Important notes: -I did not include the sling points or selector switch in the design -The part labeled "pm9upper" replaces the stock top receiver and outer barrel on the Mac11, so replace the internal parts into the new printed upper -The part labeled "pm9grip5" replaces the pistol grip backpiece on the stock Mac, held on using the same screw that is used to hold the stock backpiece. Make sure to install the upper receiver on the lower first before screwing in the grip5 part. -The foregrip is in 3 parts, consisting of the front, back that fits like a puzzle piece on the front part, and the pin that holds the grip in place. This is done for easier disassembly -a Picatinny rail were used in the front in case others want to mount their preferred foregrip or a light -The barrel and top cover should be mounted using glue; hot glue or screws should be used on the top cover for easier disassembly -Front and rear sight are friction fit -In order to access the selector, the upper must be separated from the lower before doing so. I might just make another "grip5" and upper that is easier to access the selector, but know that it will require a significant chunk of plastic that would be missing, which ruins the look imo. -The stock rear sight on the Mac must be chopped off in order to fit the new printed rear sight. -"charginghandleconnector" replaces your stock mac11 charging handle. This part is contacted by the printed charging handle I will update the kit as time goes, so please comment on anything that can be improved. Also please consider tipping as it was not an easy task to create this kit ;) Update 1: Rear sight has been changed so the stock MAC11 telescoping stock can be used Update 2: Charging handle and top cover are connected into one print Update 3: Reinforced the top plate