Airsoft MP5 End Cap

thingiverse

I've had multiple requests for this design. One of them was made earlier but I couldn't decipher the single point sling mount until recently when I finally found the time to work on it. The endcap file doesn't have any holes, while the one with a letter "i" at the end has a single hole for an eye bolt. The one labeled with a letter "u" at the end of its filename features two holes that can accommodate a U-bolt. I utilized a 1/4 inch by 2 inch eye bolt but had to trim off the threads from the end because it was too long. A 1/4 inch by 3/4 inch by 2 and 1/2 inch u-bolt was used, with the threaded ends reduced using a grinder to fit properly. The specified print settings are a 0.3 millimeter layer height, ten percent infill, two shells, no supports, and it was printed using ABS filament.