Airsoft MK23 Holster Trigger Lock Mechanism

thingiverse

This is a holster for STTI MK23, maybe fits a TM and Yeti. Fits inside the trigger guard and locks itself with a latch on the trigger part. Assembly Part: 2 mm wire Screw DIN 7991 M6 (included on Molle Clip) Spring .5mm OD 10mm +/-15mm length Any Nuprol/Cytac mount holster attachment Attach the trigger part into the Rotating Molle Clip Adapter and use M6 screw. Put the latch part with 2mm wire, heat filament to fix the shaft or the part itself in the hole area. Put spring. Ready to go. Operating: Trigger finger discipline; just push the gun trigger guard outside to the part. The latch it will open and then it stays still. To remove, use index finger to open the latch and pull the gun. Quite simple operation. New piece attached, plate with circular teeth for a better lock in the mount holster attachment. Put the two pieces together on the mount, with fresh glue or welding after for a better alignment. Resolution - 0,1 mm Put the piece in your sight or remember the trigger orientation, I had misfire a couple times. This is an airsoft part, doesn´t work in real firearms. Serious injury or death may occur.