Airsoft M9 Hush Puppy Lever

thingiverse

This is made by using only reference pictures, videos, and a airsoft WE M9 Gen 2. I wanted to make the M9 Hush Puppy Lever when I first got the mock suppressor/tracer for this replica but I was too lazy to actually get this done until now. Might get some innovated ideas to improve on this in the future. The one in the picture has been sanded down to give it that look. HP Lever #1 is the part if you decide to ever decide to cut slots into the slide. HP Lever #2 can be used as a mock lever or to mark where to cut the slots on the slide. Just use adhesive to keep it in place. HP Lever #3 is when you don't really want to do anything to the slide or frame but want to have that hush puppy look on the replica. Just use an adhesive when putting it on. I will not be held responsible if you mess up your frame, slide or the airsoft replica itself should you do the drilling, cuts or removing the internal parts. Any of these are done at your own risk. The drilling template is to make holes at the front for the two bolts. You can remove Part #48 and #55 to allow the lever lock to prevent the blowback and lever released to enable the blowback. Issue I have doing this is having cycle issues, failures to load the next bbs, slide not going back far enough to lock with empty mag, or just going full auto because the hammer bounces on the gas release valve when the gas is low. I could just need to lube it more... Hardware: M3x6mm bolts