Airsoft Kriss Vector Full Length Rail Riser - 30mm

myminifactory

I was drawn to the sleek design of the 30mm swept rail on Thingiverse by DNeves, so I decided to modify it to fit my KWA Vector. To ensure a snug fit, I expanded the picatinny slot slightly, as it had been quite a tight squeeze initially. Additionally, I increased the top rail portion by a few percent, as it was a bit too compact for my taste. The rear 30mm section of the Vector's rail remained open to allow the sling mount to move freely and avoid any obstruction from the rail. This upgraded version features countersinks specifically designed for square M3 nuts, which I had on hand from a leftover kit. However, I'll be uploading a revised model that accommodates hex nuts soon. The M3 machine screw length is 27mm; I used longer screws and trimmed them down to size. I will post new photos shortly, as the ones displayed are from an earlier iteration, but the design has remained largely unchanged. I also noticed a minor flaw in the model's rear section above the screw hole, but it's a small imperfection that doesn't impact functionality. Feel free to make any necessary repairs if you're inclined to do so.