Airsoft Hi-capa stand

prusaprinters

I recently purchased an airsoft replica of a 3.8 Vorsk Hi-capa and I obviously wanted to display it. Found the stand made by @CedricD, but it isn't intended for the Hi-capa platform. So I decided to remix his design. I also took the dimensions of the mag on the second model made by @Trollmaster_LP. Overall, the design is pretty much the same, I just widened the part where the mag sits. Dimensions of the mag : 23.20*36.14*50 mm Print Instructions : Prints as displayedI used my Anycubic Kobra, and it took around 3h with these settings : Supports : noRafts : if your bed isn't really sticky Layer height : 0.28Infill : 15% Perimeters : 3 Bottom and top layer : 3 Print speed : 70 mm/s²