Airsoft CZ Scorpion evo 3 - Selector switch

prusaprinters

Introduction : This is a knob for the selector switch of the CZ Scorpion Evo 3 by ASG. I made it to replace one of the sides of the selector (in my case the right side) to prevent the end of the knob to pinch my finger while using my replica. I took inspiration from what is already available for the real-steel version and made it as close as possible to the original version. I obviously removed the part that was pinching my finger and left a small corner to have a visual indicator. I made two versions, one without a line and one with a line to indicate which firing mode is selected. It is still kind of usable as a selector switch for going from semi to safe, which is exactly what I wanted. If you like the model, I'd love to see some makes ! If you want different versions, feel free to leave ideas or DM me.  Hardware : I reused the tiny headless screw from the original knob. To take out the original knob, put the selector on full-auto and you will see a tiny hole. Use a M1.5 Allen key to loosen the screw, and you can pull it off. When you are putting on my version, be sure to push on the tiny compression spring with something thin. I used a SIM tool.  Print instructions : Prints as displayed, with large face on the bed. I used my Anycubic Kobra, and it took around 10 min with these settings : Supports : noRafts : if your bed isn't really sticky Layer height : 0.20Infill : 20% Perimeters : 3 Bottom and top layer : 4Print speed : 40 mm/s². I printed slower to prevent loss of detailsMaterial used : Extrudr PLANX2