Airsoft 4-five Holster Trigger Lock Mechanism

thingiverse

This is a custom-made holster designed specifically for the VFC/Tokyo Marui FNX 45 airsoft gun. It securely fits inside the trigger guard and locks into place with a latch on the trigger part. Assembly Requires: * 2 mm wire * Screw DIN 7991 M6 (supplied with Molle Clip) * Spring with a diameter of 0.5mm and length between 10-25mm * Any Nuprol/Cytac mount holster attachment Attach the trigger part to the Rotating Molle Clip Adapter using an M6 screw. Next, place the latch part into position, securing it with 2mm wire. Apply heat to fix the shaft or part in the hole area. Install the spring. Your custom-made holster is now ready for use. Operating Instructions: To operate, use your trigger finger to push the gun's trigger, causing the guard to move outside and releasing the latch. The latch will then stay in place. To remove the gun, simply use your index finger to open the latch and pull out the airsoft gun. The operation is straightforward and easy to master. New Features: A new piece has been added, featuring a plate with circular teeth for enhanced locking within the mount holster attachment. Assemble the two pieces together using fresh glue or welding for optimal alignment. Achieve an accuracy of 0.1mm. Before using your custom-made airsoft part, take note of the trigger orientation to avoid misfires. Remember that this is designed specifically for airsoft use and should not be used in real firearms. Serious injury or death may occur if used improperly.