Airplane device holder with printable inserts and 6x2mm magnets

prusaprinters

I followed https://www.youtube.com/watch?v=0Sla-vIsvh4 to add a colored inlay to the model:Arrange both models in your slicer so that the inlay fills the void in the topSlice and print just the inlay. You might want to tweak your slicer settings to print a little slower for better build plate adhesionOnce the first print is done, quickly start heating your build plate again to maintain adhesionSlice and print the top in the correct position with zhop set to at least 0.3 mm (assuming your initial layer height is 0.2 mm). That'll push the print head up to 0.5 mm, which should just clear the inlay which is 0.4 mm.