Airforce Condor SS Moderator silencer

prusaprinters

<p>I was not satisfied with the stock Condor SS moderator baffles on my .22 airrifle and experimented with some 3D printed moderators , some came out louder and some slightly softer, but this design made a huge difference. I adapted the design to be a single print, without supports , drop in model.</p> <p>To use, print with PETG ( PLA doesn't hold up to the shock of pressure waves and de-laminates). its designed slightly smaller than the shroud tube to be able to fit a layer of thin felt around the baffle and then slide into the shroud tube till it mates with the barrel. The end cap is then replaced. I held the felt in place with some electrical tape on the ends. Its a tight fit, but the end result is really good - All I hear now is the hammer and hammer spring and the pellet impact</p> <h3>Print instructions</h3><h3>Category: Hobby Summary</h3> <p>I was not satisfied with the stock Condor SS moderator baffles on my .22 airrifle and experimented with some 3D printed moderators , some came out louder and some slightly softer, but this design made a huge difference. I adapted the design to be a single print, without supports , drop in model.</p> <p>To use, print with PETG ( PLA doesn't hold up to the shock of pressure waves and de-laminates). its designed slightly smaller than the shroud tube to be able to fit a layer of thin felt around the baffle and then slide into the shroud tube till it mates with the barrel. The end cap is then replaced. I held the felt in place with some electrical tape on the ends. Its a tight fit, but the end result is really good - All I hear now is the hammer and hammer spring and the pellet impact</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong> Prusa</p> <p><strong>Printer:</strong> I3 MK3S</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> 0.2</p> <p><strong>Infill:</strong> 50</p> <p><strong>Filament:</strong> any PETG any - its hidden anyay<br/> <strong>Notes:</strong></p> <p>I cleaned out the center holes with a 6mm drill bit to make sure there is no interference with the pellet</p>