Airbrush holder and hanger for Master Airbrush G233

prusaprinters

I bought an inexpensive Chinese airbrush (Master Airbrush G233) to replace a dead Paasche. I didn't find a holder or hanger that would fit so I made these. After some trial and error I was happy with the results. Print Settings Printer: Monoprice Mini V2 Rafts: No Supports: Yes Resolution: .1 mm Infill: 50% Notes: I sliced the holder with Cura using everywhere support placement and a 50 support angle. Infill % probably could be less. The hanger is sliced with solid infill for maximum strength. Post-Printing ============= I used 3/4 inch (20mm) suction cups to secure the holder to my light table. The holder works without them, but it could slip off the surface, crash to the floor and ruin your airbrush. The suction cups are a tight fit and I had to use a steel pick to pop them in correctly. You could use some other method to keep it from slipping, but this is what I used. How I Designed This Designed in ViaCAD 2d/3d v10 for mac. Sliced with Cura 3.1. Category: Art Tools