Airbrush handle fits Master Airbrushes

thingiverse

Handle was designed to fir with designed to fit Master Airbrush G233. I also found it to be compatible with Master Airbrush S68 and G22. Since my print was printed at low quality of .28mm I had to post sand part. I would also expect if higher resolution was used or SLA printer that the airbrush could be a little loose. I would expect adding a little bit of hot glue to help with this issue. If the part is too tight, I would suggest to use a hot air gun or some other method to heat up the area where the airbrush fits to mold the handle to the airbrush. As there are hundreds if not thousands of different airbrushes out on the market there will not be a one solution print for every gun.