AirBlade Eclair V2 Lite Backpack: VTX, Buzzer, GPS, antenna

thingiverse

I'm currently building a 3-inch drone with a 249g max weight goal. This will allow me to fly in Canadian cities with the new drone legislation coming June 1st, 2019. I also didn't want to cut any features and thus needed a powerful VTX, GPS, and R9M. So I'm going to use a Mach 2 U.FL VTX with a realacc antenna and a BN-180 GPS with a micro buzzer. I started with this model for the frame's screw holes positions & VTX size: https://www.thingiverse.com/thing:2825654 Then used these for the antenna mount and GPS holder: https://www.thingiverse.com/thing:3066356 Added this for the buzzer: https://www.thingiverse.com/thing:2901711 I'm not sure if this is going to evolve to include an R9MM holder and the Airblade UAV LED support, but I first need to get my printer up again and print this and see how much it weighs! In the meantime, consider this to be a WIP. - Update 2019-04-22: Added an MMCX model, the connector is too short to hope to loop it around like the original U.Fl model so I made it just come out of the back above the GPS. I also widened the VTX front opening and made an attempt at cable routing grooves for it. Finally, the buzzer is now a bit more angled and, more importantly, in the right direction so the stopper inside is on top and not bottom. Also, I'm ditching U.Fl, I broke a Mach 2 trying to desolder the pigtail, no more of that crap! - Update 2019-06-17: Made the GPS area a layer thicker on top as it would tend to be too thin and rip on the side. Also added a version for the M8Q-5883 for those in need of a Compass (*printing right now, so not tested...*)