Air Temple Bird Feeder

cults3d

A haven where tiny birds feel carefree...\nA place where they can eat and safely be...\nPerched high with friends, yet not with foes...\nWhere they can easily come and go...\nWith this thought in mind, it came to be...\nThe Air Temple was born, you see :-)\n\nInspired by the freedom of flight, This Bird Feeder is designed to be printed on FDM printers. \nFor the most precise detail, 0.1mm resolution is highly recommended. The Air Temple stands at 273mm high and 250.5mm in diameter when printed at full scale.\nThe model is a puzzle waiting to be solved. The parts fit together snugly, requiring precision assembly. \nThe knob on top (TOPNUTHOLDER) is held secure by a threaded rod and nuts. One end of the rod, with a lock nut attached, is glued into the “InnerNutHolder Main.stl” part. The TopNutHolder also cradles a nut inside, allowing it to be screwed onto the threaded rod.\nThe six roof parts and InnerNutHolder Main Part can be joined together, while the threaded rod should extend far enough to secure the TopNutHolder on top. Please refer to the photos and screenshots for guidance.\nNext, the “Pillars” can be attached to the InnerNutHolder Part. The six floor pieces can then be assembled to form the main floor (Feeder Dish). The floor can be glued onto the bottom of the pillars. Finally, the 6 roof caps, TopNutHolder cap & Bottom Cap can be installed.\n\nNote that the “FLOOR with PRINT SUPPORT.stl” and ROOF with “PRINT SUPPORT.stl” pieces already have print support integrated. For those who prefer to create their own support material, “FLOOR.stl” and ROOF.stl are included.\nOptional feature: Illuminate your Sky Temple with light. To do so, you will need to print “INNERNUTHOLDER with Light cap part.stl”,” INNERNUTHOLDER with Light insert part.stl”,”INNERNUTHOLDER with Light Lampshade VASE MODE.stl” and “INNERNUTHOLDER with Light main part.stl”. They will replace “INNERNUTHOLDER CAP.stl” and “INNERNUTHOLDER MAIN.stl”. The “INNERNUTHOLDER with Light Lampshade VASE MODE.stl” requires printing in the Spiral Outer Contour Mode without bottom layers (essentially 1 wall layer /0% infill /0 top and bottom layers). A battery, switch, charger circuit, and LED strips are necessary. Please see below and the photos for more information. \nNote that it is crucial not to glue the assembled roof to the InnerNutHolder in this case, as this would make it impossible to access the electronics for the lamp part in the future.