Air Filter for SparkMaker FHD

myminifactory

This is an extension for the SparkMaker FHD resin printer, designed by a user who recognized the lack of an air filtration system in the device. To address this issue, the user created a filter that can be placed behind the Z-axis. The SparkMaker FHD does not come equipped with an air filtration system, so this custom filter is a necessary addition for those who want to improve their printing experience. The filter is designed to work seamlessly with the existing printer components and can be easily installed by following these steps. Required Parts -------------- To build this air filter, you will need the following parts: * 1x Filter Pad (approx: 190x55x20mm) * 1x 2.5mm DC Jack Y-cable * 1-2x Blower Fan 24V (50x15) * 1-2x M4x25 Screw + 1-2x Washer + 1-2x Nut * or 1-2x Self-Tapping Fan Screw Printing --------- To print this air filter, you will need to use a 3D printer. The design is optimized for printing without support, but it's recommended to print the upper part upside down. Installation ------------- To install the air filter, follow these steps: 1. Insert the Filter Pad into the Upper Part. 2. Put the Lower and Upper Parts of the Chimney Together. 3. Cover the Middle Hole with Some Tape to Keep the Printer Clean. 4. Connect the Fan to One End of the 24V Y-cable (eight by directly soldering it to one end of the cable, or installing a proper plug on the fan). 5. Install the Left Fan with M4 or Self-Tapping Screw. Make Sure That the Cable is Installed Correctly in the Cable Channel Behind the Fan. 6. Cut the Embedded Hole on the Right Side and Install a Second Fan (Optional). 7. Carefully Cut the Cover According to the Drawing. 8. Remove the U-Cover from the Z-Axis. 9. Slide the Air Filter Over the Z-Axis. 10. Use the 6 Screws from the U-Cover to Secure Air Filter. By following these steps, you can successfully install the air filter on your SparkMaker FHD resin printer and enjoy improved printing results.