AIR DRYER

thingiverse

https://youtu.be/4-gsUdbgRWc Hello everyone We made the installation for the garage, it has a cellar and because of it, the humidity in the garage is quite high. Everything is quite simple, we ordered the Peltier Element on Alik, its characteristics are 40x40mm 12V, but the current consumption varies (depends on the thickness of the element), in our case about 5 amps. The water block under the elements is also on free sale on Ali Express and is cheap, we took 80x40mm, under two elements. Our elements are connected in parallel with each other. The pump is the cheapest that we could find, the reservoir and radiator have been lying for a long time from an old computer. The most important thing in the Peltier element is to remove heat well from the hot part, then it will freeze well, the more we remove it, the lower the temperature of the cold part. About the fan blowing on the aluminum plate. At the time of Assembly, the temperature was 15 degrees and the Peltier element cooled the plate to minus values. With a fan, we raised the temperature on it to avoid freezing, and at the same time increased the volume of passing air for condensation. If you do not take into account the power supply (any 12V unit of sufficient power will do), the tank and radiator with coolers that we had lying in the garage, then the installation cost us$ 15 (Peltier 2 PCs, water block, pump)