Air compressor part cooler

thingiverse

This part is designed for the Replicator 2x E3D-v6 bowden Upgrade. I was fed up with tiny cooler fans that couldn't move enough air and bought a 60l/min air compressor made for fish tanks, which can be found on eBay as this one. It's relatively quiet compared to piston compressors. The part is supposed to be as simple as possible (I didn't quite succeed), but it doesn't need any screws - the air ducts just slide onto the carriage from the sides. I'm using 10 mm OD 8 mm ID PVC hose. Print two copies of the air_pump_cooler_mkbot2x.stl on opposite sides, one should be a mirror image, and also print an air tee or use this prepared stl. File down any rough edges if needed and assemble everything as shown in the photos. The source freeCAD files are attached, but they're a bit of a mess!