AILERON FLAP SET
thingiverse
Human: Printed flap + ailerons One aileron needs: (AIL16.5 A W+A)+(AIL16.5 Ba/w)+(AIL16.5 A W+A) mirrored. Total length is 350mm. You can print short aileron just printing until the desired height (print vertical). Longer ailerons need scaling on Z axis. Same with Flap piece, but with total length of 360mm Internal support are included in each piece. Use an X-acto to remove it. Print vertically and use multi-process with this config: numbers indicate how many lines or layers for outline, back, top + % infill. The general criteria for printing are: 1-2-0 15% until hinge section (base section) 3-2-2 100% two layers before and after hinge section 1-0-0 0% the rest of the piece Union pieces could be used with 100% infill at a small weight penalty. Just try your best for your printer. Print slow! Vertical pieces as flap, flap hinge, and aileron need brim or raft for stability. In my basic Anycubic I3 (Anet A8 clone) speed is 1800mm/sec. I include a factory file for Simplify3D users 16.5 indicates the height in mm of the trailing edge of the wing; check this before printing to scale Y axis. The axis for flap hinge is a 2mm bolt and nut, but could be a 1.8mm wire, blended in L form and glued to the support. Aileron works great with 2mm carbon fiber rod, but again, could be changed to wire (weighting a little more) Use a wire or manual drill to clean holes before mounting. In an aileron, I prefer getting tight holes on the moving part (2mm) and a little loose in the fixed part of the hinge (2.2mm).
With this file you will be able to print AILERON FLAP SET with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on AILERON FLAP SET.