Agisis Face Hugger (simplified)

cults3d

This is a pieced together version of Agisis's model face hugger. For me i found splicing the parts to a single part far more easier to manage post print. Print settings: .12 layer height 4 layer wall (1.6mm) 40% infill Rafts used with 5mm margin Supports used with 75 degree over hang angle Post print: Remove supports and rafts Knife off additional material Exacto or surgical knife the additional material Gas torch other imperfections back into the surface(remember plastic is a terrible heat conductor, allow to cool between areas) Build: A hard push and a wiggle and the joints should lock in. The only joint i had loose was the rear body to tail part which i welded into position using print material and gas torch. Paint: Plastic primer or filler primer Then your choice of colours for the final product 22/9/17. Added the More detailed body complete file as reequested. Some of the bottom features are extruded to show of these extra details.