Afinibot A1 Carriage

thingiverse

I first discovered that my printer started wobbling at the Z-axis tower after extensive usage. Despite numerous attempts, I was unable to get it working properly and eventually broke the hinge. To hold it in place, I now use a clip instead of glue or heat. I downloaded the original design and printed it out, but unfortunately, it didn't fit. I decided to modify the design myself, which required a significant amount of time and experimentation. After much trial and error, I finally came up with a revised design that should be useful for others. Here are my print settings: * Printer: Afinibot A1 * Rafts: Not necessary * Supports: Can be omitted * Resolution: 0.2mm * Infill: 100% * Notes: To print ABS with a rim, use the following settings. If you only want to replace the Z-axis tower, print one unit. Otherwise, print three units.