Aero Lite Creality Titan Aero Mount

thingiverse

Remix of MP23Racing's Great Aero Mount. To create the mounting plate, I cut it in half so it could be printed on its side without supports. A lip was added to go over the top of the carriage bracket for stability. An extra bolt hole was also added to help support the duct end, and a post was added for tying the wiring harness. For the duct, when slicing, only put supports in the opening where they can be easily removed. If too many supports are used, they cannot be removed. Also, make sure to use parallel lines for the top and bottom layers, 45 degrees from the bottom of the duct or the roof will fail without supports. I plan on remixing it again at a later date when I learn Fusion360 so no supports will be needed. Edit: A dual 5mm LED light bar was added. Use two 12v 5mm LEDs wired in series if using an Ender 3 or any printer with a 24v power supply. Wire the LEDs in parallel if using a CR-10 or any printer with a 12v power supply.