Aegis Saber Raven

thingiverse

Aegis sabre raven Fixed model. Landing gear recreated from scratch. All gear doors, cargo doors, and canopy can be attached open or closed. I've not printed this so a few things to take note of. 1. The lower engine inserts look like they may have an issue sliding in with the wing configuration. I tried to rectify this many ways, but the model just kept getting messed up. Suggestions are to keep sanding the lower engine inserts until they clear the wings and slide in, or heat the front of the wings with (Hot water if PLA) then bend the wings up a little, insert the engine intakes, then repeat to bend the wings down. I tried to create the model with the lower intakes attached, but the mesh ended up too big for Thingaverse. 2. One upper VTOL on body-a.stl is there, the other not so much. I've included a vtol model to replace the missing one. The goal was to remove them as they repaired bad. and glue in the model I made by hand. But any attempt at removing the existing three vtol engines results in a broken mesh that is near impossible to repair at a decent file size. I suppose you could cut/melt/drill out the wacked vtols and glue in the models I made. But they are tiny and you probably wouldnt notice. Up to you. 3. The cockpit is a bit off. lower part of seat and stick are in a repair mesh that took over the lower part of the model. you can have the canopy glued up or closed, and ladder out or closed off with door. 4. As normal the model had no landing gear, I tried to make some by hand. You get what you pay for. NOTE: I included a working.3mf file for part assembly reference. Ship Scale ------------------------------- CIG Scale Length: 24.0m Model Scale LEngth: 240mm As I've stated before. I don't make these models snap together. You will need to do some cutting and sanding to get some parts to seat properly.