ADXL345 Bracket for Sprite SE Neo DD

prusaprinters

It is in times of great need when inspiration comes to your door.I was looking for a bracket so I can mount my ADXL345 accelerometer on my Ender 3 V2 Neo, which I have modded with a beautiful firmware, nothing else than Klipper. So, I thought I have an ADXL345 sitting arounf gathering dust, why not put it in good use. Klipper gives you the ability to read frequency of vibrations from an accelerometer and with the Input Shaping feature, make ringing disappear.My only problem was that I also modded my Ender 3 V2 Neo with a direct drive extruder, the Sprite SE Neo, which was the only one I could find whihc works with Neo version. After searching a bit I discovered that there is not a bracket which meets my needs so I decided to design one.It's my first time designing a part and after many hours and tries, I think its pretty good. But since there is always room for improvement, let me know in the comments, and from your makes what else you'll need and I'll do my best to provide it.As a side note, I used M3x3 flat screws to place it on the extruder, and with pushing a little bit I tried to hold it in place pretty good. But I think that the best would be to use M3x4 screws to place it without any problems.Also, it doesn't show in the photos because I added it after, but I used brass inserts which put with a soldering iron in the holes of the standoffs to screw ADXL and keep it in place.  I carefully inserted them with the iron at 140 Celsius but I would suggest going lower if your iron gives you this flexibility, because walls are too thin and they melt pretty quickly.