Adpators for geeetech 20x4 to Prusa MK2 lcd case

thingiverse

I inserted a Geeetech 20x4 LCD into an Original Prusa MK2 LCD case. For the most part, it fits neatly. The display lines up, and the SD card aligns properly. Slightly out but close enough, the screws fit in their designated spots. The knob shaft and reset button sit in the correct location, though they're positioned too far back/short. These two components resolve this issue without needing to modify the LCD case parts. Knob_mod is an extension added to the knob clip; it's glued onto the existing part. (Ignore the screw thread in the image - it was only there temporarily to ensure proper alignment while gluing.) Reset_mod is an extension attached to the reset button, clipping onto the current case components.