Adjustable Width Napkin Holder

thingiverse

This is a super easy adjustable width napkin holder that expands or contracts to hold more or less napkins as needed. It prints out perfectly as is, with no supports required, and assembles easily like shown. This design was inspired by Zydac's Extendable Napkin Holder on Thingiverse. This model is simpler and should be easier to print too. Each half measures 125mm wide, 125mm tall, and 60mm long. So the holder can extend from around 50mm wide to almost twice that, about 95mm wide. The model was designed without tight tolerances for a snug fit. Therefore, it's not a good idea to slide the holder all the way together, as it might be hard to reopen. If this happens, you can use a butter knife to slide between the cracks and loosen things up until you can get a good grip to pull the pieces apart without breaking them.