Adjustable torch clamp

thingiverse

Here is the rewritten text: Using Flashforge Dreamer with Flashprint standard ABS settings at 80mm pre extrusion, I achieved excellent results. The extruder temperature was set to 220 degrees Celsius, while the plate temperature reached a comfortable 105 degrees Celsius. All parts were printed simultaneously without any raft or brim, but automatic supports were used - although they may not have been strictly necessary. The prints turned out dimensionally accurate to the 3D model, except for the swivel, which began to lift off the bed and developed a slightly warped appearance. The nuts and bolts employed were ordinary machine parts I happened to have on hand, so be sure to check their sizes before attempting a print. With a 15% infill rate, the clamp proved weak and tended to open when the clamping screw was tightened. I've since updated this design to utilize standard machine screws and nuts for greater consistency. The linkage and torch clamp now feature M4 machine screws and nuts, while the clamping bolt is secured with an M6 bolt and nut. Print Settings: Printer Brand: FlashForge Printer Model: FlashForge Creator Pro Rafts: No Supports: Yes Resolution: 0.18mm layer height Infill: 15%