Adjustable Tablet Support

thingiverse

A steady and adjustable structure that designed to hold a Tablet / iPad in any desirable view angle, and can be partially folded for easy carry. My design approach was to build as much as possible a small structure that will accommodate up to 12 inch Tablets (Tested) with minimum printing time. Assembly Instructions: Hardware required: 2 (two) M3X35 mm Stainless Screws 1 (one) M3x40 mm Stainless Screw 2 (two) M3 Self Lock Stainless Nuts 1 (one) M3 Stainless Hex Nut 1 (one) M2.5X8 mm Stainless PH Pan Screw 1 (one) M2.5 Stainless Hex Nut FAST GLUE of your choice. Source of Supply: For above Items 1 and 2 : https://tinyurl.com/2kzyb3wv For above Item 3: https://tinyurl.com/47ssep6d For above Items 4 and 6: https://tinyurl.com/536raerw For above Item 5: https://tinyurl.com/2p8h2u8y The whole assembly should take 10-15 minutes long. Some of the pictures depicts and helps to understand these instructions. Install the LOWER HINGE to the Main part using M3X35 screws and self-lock nuts. Use the pictures for the proper position. Insert the SUPPORT SHELVE into the MAIN part. This item should snugly fit into the 3 square openings in the opposite side of the hinges protrusions on the MAIN part. No glue is required here. Attach the HINGED SLIDE to the MAIN part using M3X40 screw and nut. Use the pictures for the proper position. Insert the M2.5 hex nut to the recced hex position on the HINGED SLIDE using small amount of FAST GLUE. Let it dry. Check and clean residue. Fully insert the M2.5x8 screw into the top hole of the SCREW KNOB, use very small amount of FAST GLUE to keep the screw head inside the KNOB. The screw must penetrating out the KNOB bottom about 3-4 mm. See pictures. Use the CAP to cover the KNOB - fast glue it if required. Attach the assembled KNOB to the HINGED SLIDE, then Insert the SLIDE into the HINGED SLIDE. The position of the SLIDE can be adjusted by loosing/tightening the KNOB for fine calibration of the desired tilt of the structure. Would like to see builds and any comment.